Follow the procedure to perform a lamination module cleaning on Evolis Primacy 2:
Maintenance accessory needed: Evolis special adhesive cleaning card.
1. Remove lamination film from the lamination unit
2. Launch the lamination module cleaning wizard on the Evolis Premium Suite.
3. Remove the two protective films on both sides of the special adhesive card.
4. Insert the adhesive card into the opening above the output hopper at the rear side of the module. The card goes inside the printer.
5. Once the cleaning cycle is complete, the used card is ejected from the printer.
6. Put the lamination film back.
7. Close the door of the lamination unit. The printer is ready to operate again
Recommended cleaning cycle: once a year or every 10,000 cards, depending on the work environment.